OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D1E

Hybrid/EV Battery Pack Coolant Control Valve B Control Circuit High

P0D1E is the short-to-voltage counterpart for coolant control valve B: the controller sees its drive line high at a moment when it should be low. P0D1E is not described in any public manufacturer document. For valve A, GM documents the matching test on the Chevrolet Volt 2011 and Cadillac ELR 2016: driver line 1 reads high while the valve should be stopped or moving forward, system voltage above 9 V or 10.2 V, 90 out of 100 checks, Type B with the lamp lit on the second trip. Because the check runs in the opposite direction of travel to the low test, the stored code already hints at which wire is affected. Pinched wires touching a supply line or a driver stage that will not switch off are the usual suspects. Battery temperature control falls back to a default. Short to ground is P0D1D, open circuit P0D1A.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 1E

Possible causes

  • Valve B driver wire pinched against a supply line high
  • Output stage in the controlling module stuck high medium
  • Damaged or contaminated connector bridging two pins low

Symptoms

  • MIL after two trips (where the maker uses a two-trip code)
  • Battery thermal management in fallback mode, charging or power limited

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0D1E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication