OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D1D

Hybrid/EV Battery Pack Coolant Control Valve B Control Circuit Low

P0D1D reports that the drive line of coolant control valve B reads too low, which normally means a short to ground. No manufacturer publishes P0D1D itself. The closest documented test is GM's check of valve A in the 2011 Chevrolet Volt and the 2016 Cadillac ELR: the motor-driven valve has two driver lines, and a low reading on line 1 while the valve should run in reverse, with system voltage above 9 V or 10.2 V, sets the code after 90 failed samples out of 100; it is Type B, which lights the MIL only on the second trip. A comparable logic is to be expected for B. Typical findings are a wire chafed through to the body, water in a connector or an internal short in the valve motor. While active, the valve stays where it is. Short to voltage is P0D1E, open circuit P0D1A.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 1D

Possible causes

  • Valve B driver wire chafed and shorted to ground high
  • Moisture or corrosion in the valve connector medium
  • Internal short in the valve motor low

Symptoms

  • MIL after two trips (where the maker uses a two-trip code)
  • Battery cooling or heating restricted, charging or power limited

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0D1D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication