OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D1B

Hybrid/EV Battery Pack Coolant Control Valve B Performance/Stuck Off

P0D1B is stored when coolant control valve B of the battery loop is electrically intact but fails to reach or hold the position the controller asks for, or stays in its off state. How a maker judges this varies: for valve A, GM's 2011 Chevrolet Volt learns the end stops, expects the target within 1.5 s and watches for drift above 3 %, while Audi and Toyota infer a wrong valve state from coolant temperatures. No such table or bulletin is published for valve B, so P0D1B appears in no public manufacturer document. CARB asks for a functional check of battery cooling performance wherever feasible. Debris, a seized valve body, a worn actuator or a calibration that judges too tightly are plausible. Cooling or heating of the pack then suffers. The opposite case is P0D1C.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 1B

Possible causes

  • Valve B mechanically stiff or blocked by debris medium
  • Worn valve actuator that no longer reaches its target medium
  • Diagnostic limits in the module software set too tightly low
  • Low coolant or trapped air distorting the temperature-based check low

Symptoms

  • MIL or battery thermal system warning
  • Battery temperature rises during fast charging or hard driving
  • Charging or drive power limited

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0D1B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication