OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D1A

Hybrid/EV Battery Pack Coolant Control Valve B Control Circuit/Open

P0D1A flags an open or otherwise faulty drive circuit of coolant control valve B, a second actuator in the coolant loop of the hybrid or EV battery. Which physical valve gets the letter B, and what it switches, is up to the vehicle maker. No manufacturer documents P0D1A in a public bulletin or OBD table. The best documented analogue is valve A: Mercedes battery management reports its actuation as faulty or interrupted (LI83.30-P-061224), and CARB requires every electronic output used for battery heating or cooling to be checked for circuit faults. A broken wire, a corroded plug or an open valve coil are the usual findings. With the valve unusable the pack may run too warm or too cold, so charging and power can be limited. Shorts to ground or voltage are P0D1D and P0D1E.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 1A

Possible causes

  • Broken wire or corroded connector in the valve B drive circuit high
  • Open coil or motor winding inside valve B medium
  • Faulty output stage in the controlling module low

Symptoms

  • Hybrid or EV system warning and MIL
  • Reduced charging or drive power because battery temperature cannot be managed

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0D1A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication