P0D0D
Battery Charging System Positive Contactor A Control Circuit High
P0D0D means the control line of positive charging contactor A sits too high, typically from a short to a supply voltage or a driver that no longer switches off. The coil may then stay energised, so the contactor could close without a command, which the module has to prevent. No manufacturer documents P0D0D publicly; on the Chevrolet Volt GM folds the short to power into P0D0A and flags it when the off-state output stays within 0.4 V of supply. CARB requires plug-in vehicles to monitor charging components. Causes are crossed or chafed wiring and a failed driver inside the control module. Low readings are P0D0C, opens P0D0A, a welded contactor P0D08. The system normally blocks charging until the fault is gone.
Possible causes
- Control wire shorted to a supply voltage high
- Driver stage in the control module stuck on medium
- Open ground return of the coil letting the line float high low
Symptoms
- Charging blocked
- Charging or high-voltage system warning
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D0D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.