P0D0A
Battery Charging System Positive Contactor A Control Circuit/Open
P0D0A covers the drive circuit of positive charging contactor A: the module compares the commanded state of its driver with the voltage and current it actually sees on the coil line. GM spells this out for the Chevrolet Volt and Cadillac ELR: with the driver off, an output above 4 V means an open line and one close to supply voltage a short to power; with the driver on, coil current below 57 mA (Volt 2019: 194 mA) also counts as open. 40 of 50 samples at 12.5 ms set the code. The 2011 and 2014 Volt and the ELR rate it Type A, the 2016 and 2019 Volt Type B with MIL after two trips. GM adds that the test cannot see a short to ground. Range/performance, low and high are P0D0B–P0D0D. Without a working contactor the car will not charge.
Possible causes
- Open or high-resistance coil control wire or connector high
- Contactor coil open medium
- Control wire shorted to a supply voltage low
- Faulty high-side driver in the control module low
Symptoms
- Malfunction indicator lamp (GM Type A or B)
- Vehicle does not charge
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D0A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.