P0D05
Control Pilot Charging Ventilation Switch Stuck Off
Stuck Off for the ventilation switch means the module commands the switch closed, yet the pilot does not drop to the level around 3 V that marks a request for charging with ventilation. Possible causes are a switch that no longer closes, an open resistor in the roughly 270 Ω branch, or a measuring fault in the module. Because ordinary charging takes place without a ventilation request, this fault rarely restricts charging; it mainly shows up during the self-test the module runs on the circuit. No manufacturer documents this code publicly; GM's Chevrolet Volt performs that kind of self-test as P0D01, with a normalized pilot voltage window of 0.04-0.10, and CARB requires plug-in vehicles to monitor the charging system. The opposite case is P0D06, circuit faults are P0D00 to P0D03. Expect a stored code and charging that still works.
Possible causes
- Ventilation switch in the module no longer closing high
- Open resistor or solder joint in the ventilation branch medium
- Pilot measuring fault in the charging module low
Symptoms
- Stored code, charging normally still possible
- Charging system warning in the cluster on some vehicles
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0D05
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.