P0D04
Control Pilot Charging Ventilation Switch Intermittent/Erratic
P0D04 covers short, irregular disturbances in the ventilation switch circuit: the signal drops out or flickers, while lasting faults would be stored as P0D00, P0D02 or P0D03. Worn or corroded contacts in the charge inlet or module connector, and wires that lose contact under vibration, are the obvious suspects. Whenever the ventilation switch closes even briefly, it pulls the pilot toward about 3 V, so a station without ventilation suddenly sees a demand it cannot meet and may switch off. No manufacturer documents this code publicly; GM's Chevrolet Volt shows how the switch is checked via P0D01, and CARB requires plug-in vehicles to monitor the charging system. In practice the driver notices charging sessions that stop for no obvious reason and a code that comes back after clearing.
Possible causes
- Loose or spread terminal in the ventilation switch circuit high
- Corrosion or moisture in the charge inlet or module connector medium
- Chafed wire with contact loss under vibration low
Symptoms
- Charging sessions stop without obvious reason
- Code returns after clearing
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0D04
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.