P0D02
Control Pilot Charging Ventilation Switch Circuit Low
P0D02 marks the control or feedback line of the ventilation switch as too low, usually a harness wire grounded somewhere along its route or a charging module driver that has failed shorted. That switch places a resistor of about 270 Ω across the pilot so that the level falls to roughly 3 V, the state in which a vehicle demands charging with ventilation. No manufacturer documents this code publicly; GM's Chevrolet Volt evaluates the same switch by the pilot level it causes (P0D01, ratio 0.04-0.10 in a self-test), and CARB requires plug-in vehicles to monitor the charging system. If the short holds the switch closed, a station without ventilation will refuse to deliver power; if it holds it open, the fault mostly shows only as a stored code. The high-side fault is P0D03, the open line P0D00.
Possible causes
- Ventilation switch control or feedback wire shorted to ground high
- Shorted driver stage in the charging control module medium
- Corrosion in a connector bridging the line to ground low
Symptoms
- Charging refused at stations without ventilation
- Stored code without noticeable effect
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0D02
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.