OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0D00

Control Pilot Charging Ventilation Switch Circuit/Open

Some battery types can give off gases while charging; for that case the conductive charging standards provide a state in which the vehicle asks the station for ventilation. The vehicle signals it by switching a much smaller resistor of about 270 Ω onto the pilot, which drags the level to around 3 V; the station then only delivers power where ventilation is assured. P0D00 reports that the control circuit of this ventilation switch is open. No manufacturer documents this code publicly; GM's Chevrolet Volt monitors the switch for plausibility only (P0D01, normalized pilot voltage 0.04-0.10 in a self-test), and CARB requires plug-in vehicles to monitor the charging system. During normal charging the switch stays open, so an open circuit often goes unnoticed except for the stored code. Shorts are P0D02/P0D03.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberD / 00

Possible causes

  • Open control wire or loose connector of the ventilation switch circuit medium
  • Ventilation switch or its resistor branch open inside the module medium
  • Failed driver stage in the charging control module low

Symptoms

  • Stored code, charging usually still works
  • Charging system warning in the cluster

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0D00

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication