P0CFB
Control Pilot Charging Switch A Circuit High
P0CFB is the high-side counterpart: the control or feedback line of charging switch A, which loads the pilot with an extra 1.3 kΩ to request charging, shows a voltage above its valid band. Typical are a short to a supply voltage in the harness or connector, or an output stage in the charging module that no longer pulls the line down. No manufacturer documents this code publicly; the closest documented test is GM's P0CF9 on the Chevrolet Volt, which judges the switch by the pilot voltage it produces in a self-test (ratio 0.14-0.28), while CARB requires plug-in vehicles to monitor the charging system. Low readings are P0CFA, an open line P0CF8, dropouts P0CFC. For the driver the station typically stays in the plugged-in state without supplying power, or a session cannot be ended cleanly.
Possible causes
- Switch control or feedback wire shorted to a supply voltage high
- Output stage in the charging module no longer switching to ground medium
- Lost ground at the switch letting the line float high low
Symptoms
- Vehicle detected at the station but no energy flows
- Charging cannot be stopped normally
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0CFB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.