P0CFA
Control Pilot Charging Switch A Circuit Low
Charging switch A shifts the control pilot from the connected state at about 9 V to the charge-request state at about 6 V by switching in an extra 1.3 kΩ path. P0CFA indicates that the control or feedback line of this switch reads too low, typically a harness wire touching ground or a driver stage in the charging module that has failed shorted. No manufacturer documents this code publicly; CARB requires hybrids and plug-ins to monitor the charging system, and GM's Chevrolet Volt checks the same switch only indirectly through P0CF9 by measuring the pilot voltage it causes in a self-test. Depending on the design, a grounded control line can hold the switch permanently closed or permanently open. The high-side fault is P0CFB, the open circuit P0CF8. Charging may then start unexpectedly or not at all.
Possible causes
- Switch control or feedback wire shorted to ground high
- Shorted driver stage in the charging control module medium
- Corrosion in the inlet or module connector bridging to ground low
Symptoms
- Charging does not start, or starts as soon as the plug is inserted
- Charging fault message in the cluster
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0CFA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.