OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CF6

Control Pilot Circuit High

A pilot level above the valid range usually means the line touches a supply voltage, or the measuring path in the module reads wrongly. GM evaluates it on the Chevrolet Volt (VICM/HPC2, 2012-2019) only while no cord is connected and the car is travelling at 8 km/h or faster, a moment when the pilot should be practically dead: a normalized pilot voltage (pilot voltage over battery voltage) above 0.55, or 0.58 in the 2012 table, in 30 of 50 samples at 100 ms sets the code. It is Type A, so the MIL comes on after one trip. The low-side counterpart is P0CF5, plausibility errors belong to P0CF4, an open line to P0CF3. With the pilot held high, the vehicle cannot pull the level down to request energy, and the station does not switch power on.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / F6

Possible causes

  • Pilot wire shorted to a 12 V feed in the harness or inlet high
  • Pilot measuring circuit in the charging control module reading too high medium
  • Moisture in a connector coupling a neighbouring voltage onto the pilot low

Symptoms

  • Malfunction indicator lamp on after a drive (GM Type A)
  • Charging does not begin at the station
  • Charging fault message in the cluster

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0CF6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication