P0CF1
Hybrid/EV Electronics Coolant Temperature Sensor A Circuit High
The sensor signal rises nearly to the 5 V reference, the typical picture of an open circuit, an unplugged connector or a signal wire shorted to voltage. GM sets it above 98 % of the reference (4.9 V) in all published tables from the 2011 Volt to the 2019 HPC2 controller, 16 of 20 samples at 250 ms or 4 s within 5 s, Type B, two trips. Chrysler's Pacifica Hybrid shows it in practice: STAR case S2008000119 (2020, revised 2021) links P0CF1 together with P1B71-00 and B12B0-00 and the message Service Hybrid Electrical System to water entering the grey 16-pin inline connector XY291A under the battery skid plate. Cleaning and dielectric grease cure light moisture; corroded pins mean new dash and underbody harnesses. P0CF0 is the grounded counterpart.
Possible causes
- Water or corrosion in an underbody inline connector (Chrysler Pacifica Hybrid XY291A) high
- Open signal or ground wire, or unplugged sensor high
- Sensor element open internally medium
- Signal wire shorted to a voltage source low
Symptoms
- Service Hybrid Electrical System or similar warning
- Scan tool shows an implausibly low coolant temperature
- Charging or drive power limited
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0CF1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.