P0CF0
Hybrid/EV Electronics Coolant Temperature Sensor A Circuit Low
The signal voltage of the electronics coolant temperature sensor drops close to zero, which almost always means the signal wire touches ground or the sensor is shorted internally. Low refers to the voltage, not to the temperature. GM sets the code below 2 % of the 5 V reference (0.1 V) in the 2011 Volt, the ELR and the 2016 HPC2 table, and below 4 % (0.2 V) in the 2016 Volt and the 2019 HPC2 table. Counting is 16 of 20 samples at 250 ms or 4 s in a 5 s window, with more than 9 or 10.2 V supply, Type B, two trips. The open or high case is P0CF1, a plausible but wrong value is P0CEF. With no usable reading, the controller assumes the worst, runs the pump and can limit inverter and charging power.
Possible causes
- Sensor signal wire shorted to ground high
- Internally shorted temperature sensor medium
- Water in the connector bridging signal and ground medium
Symptoms
- Malfunction indicator lamp or hybrid warning
- Scan tool shows an implausibly high coolant temperature
- Pump running constantly, power or charging reduced
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0CF0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2011/11OBDG01 HYBRID Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2016/16OBDG01 Hybrid Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2016/16OBDG02 Hybrid Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2019/19OBDG01 Hybrid Diagnostics.pdf
- law.cornell.edu/regulations/california/13-CCR-1968.2