OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CEF

Hybrid/EV Electronics Coolant Temperature Sensor A Circuit Range/Performance

The sensor stays electrically within range but reports a temperature that does not fit its surroundings. GM uses two kinds of comparison. In the 2011 Volt and the ELR it is checked against the high-voltage charger temperature with the pump running at 30 % or more for over 60 or 300 s; the limit is 38 to 40 °C (2011) or 35 °C (ELR). From the 2016 Volt on the test runs once after a long rest (propulsion off over 18,000 or 21,600 s, pump and A/C off for 3,600 s) and compares with outside air, transmission fluid and A/C high-side temperature; limits are 27/27/28 °C, 21/35 °C in 16OBDG02. GM uses 32 of 40 samples or 8 s in 10 s, Type B, two trips. Hard circuit faults are P0CF0/P0CF1, noise P0CF2. A wrong reading misleads the cooling and power limits.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / EF

Possible causes

  • Sensor element drifted and reads offset from the real coolant temperature high
  • Added resistance from corroded terminals shifting the signal medium
  • Genuine temperature gap from poor flow or air in the electronics loop medium
  • Comparison sensor (charger, outside air or transmission fluid) reading wrong without its own code low

Symptoms

  • Malfunction indicator lamp on, often without noticeable drivability change
  • Electronics coolant pump runs at odd times or longer than usual
  • Occasional power or charging limitation

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0CEF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication