OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CEE

Hybrid/EV Electronics Coolant Temperature Sensor A Circuit

Sensor A reports the coolant temperature in the loop that cools the hybrid power electronics. P0CEE is the general circuit code for it, used where a controller does not tell low from high. No manufacturer documents this code publicly; GM, for example, reports the same sensor only through P0CF0 (below 2 or 4 % of the reference voltage), P0CF1 (above 98 %) and the plausibility and noise checks P0CEF and P0CF2. CARB requires temperature inputs of inverter cooling systems to be checked for open circuits and for readings outside their valid band, so a controller may file an open or shorted sensor here instead. Because the system can no longer judge the coolant, it usually runs the pump harder and caps inverter and charging power as a precaution.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / EE

Possible causes

  • Loose, corroded or water-soaked sensor connector high
  • Damaged signal or ground wire of the sensor medium
  • Failed temperature sensor element medium

Symptoms

  • Malfunction indicator lamp or hybrid system warning
  • Electronics coolant pump runs continuously
  • Reduced drive or charging power as a precaution

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0CEE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication