P0CED
Hybrid/EV Electronics Coolant Pump A Enable Circuit
Some electronics coolant pumps receive two signals: a speed command and a separate enable wire that switches the pump on. P0CED concerns that enable wire. In GM's 2011 Volt (11OBDG01) any open or short on it sets the code after 16 of 20 samples at 250 ms with more than 9 V supply, Type B, two trips. Later GM controllers split the short cases into their own codes and keep P0CED for an open: the HPC2 tables 16OBDG02 and 19OBDG02 fail it when, with enable commanded on, the line rests between 1.14 V and 2.81 V, a level that points to a floating wire. The speed command line itself is P0CE9 to P0CEC. Without enable the pump stays off even though its command looks normal, so electronics temperatures climb and power may be reduced.
Possible causes
- Broken enable wire or terminal pushed out of the connector high
- Enable wire shorted to ground or voltage (codes it on older GM controllers) medium
- Defective enable input inside the pump low
- Faulty enable driver in the control module low
Symptoms
- Malfunction indicator lamp on
- Electronics coolant pump remains off
- Reduced power or charging rate when electronics get warm
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0CED
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.