P0CEC
Hybrid/EV Electronics Coolant Pump A Control Circuit High
P0CEC flags a pump control line that is held too high, normally a short to battery voltage on the output. GM's HPC2 tables of 2016 and 2019 (16OBDG02, 19OBDG02) look for it while the pump enable is on and the commanded duty cycle is between 0 and 10 %: a line reading high when it should be nearly off counts as a failure, and 16 of 20 samples at 250 ms set the code, Type B, two trips, with system voltage above 10.2 V. A pump with a line pinned high may run constantly or ignore speed requests, depending on its electronics. Open circuits belong to P0CE9, a line pulled low to P0CEB, the separate enable wire to P0CED. The fix is usually in the harness: a pinched wire touching a feed or moisture in a connector.
Possible causes
- Control wire shorted to a 12 V feed in the harness high
- Moisture or corrosion in the pump connector linking supply and control pins medium
- Pump electronics feeding voltage back onto the control line low
- Output stage in the control module stuck high low
Symptoms
- Malfunction indicator lamp on
- Pump runs permanently or does not respond to speed changes
- Possible power limitation of the hybrid system
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0CEC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.