OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CE9

Hybrid/EV Electronics Coolant Pump A Control Circuit/Open

The hybrid controller checks the control line of the electric pump that moves coolant through the power electronics loop, which in GM's Volt and ELR serves the inverter module and the high-voltage charger. GM tables from 2011 to 2016 fail it when the output driver reports an open line or a short to ground or voltage in 16 of 20 samples at 250 ms. The 2019 HPC2 table measures line current instead: below 200 mA or above 3 A while the pump is commanded on, below 120 µA while it is off, for 4 s within a 5 s window. All variants are Type B, two trips. Audi logs P0CE900 on the e-tron and Q8 e-tron in thermal management unit 00C5. P0CEB and P0CEC split the fault into low and high, P0CEA covers pump function. With the pump idle, inverter and charger heat up and power is reduced.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / E9

Possible causes

  • Open or chafed control wire, or corroded connector at the electronics coolant pump high
  • Failed electronics in the pump itself, drawing no current or far too much medium
  • Coolant loss from a damaged hose letting the pump run dry (Audi e-tron/Q8 e-tron bulletin) low
  • Faulty output driver in the hybrid or thermal management control module low

Symptoms

  • Malfunction indicator lamp or hybrid/drive system warning on
  • Reduced drive power because inverter and charger temperatures rise
  • Charging power reduced or charging interrupted
  • Pump not audible after switch-on when commanded via scan tool

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0CE9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication