OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CE4

Hybrid/EV Battery Pack Coolant Control Valve Position Sensor Circuit

P0CE4 is the general circuit fault of the position feedback from the battery coolant control valve. On motor-driven valves the actuator reports its actual position as a share of the sensor supply voltage, letting the controller confirm that coolant really flows toward the battery, chiller or heater. GM's Volt and ELR monitor this feedback but report its electrical faults as P0CE6 and P0CE7; no manufacturer publicly documents P0CE4 itself. CARB requires battery thermal management inputs to be checked for circuit faults. Likely causes are an open signal, reference or ground wire, a damaged connector at the valve or a failed sensor inside the actuator, which is normally replaced together with the valve. Without feedback the controller may park the valve and limit charging or power. Implausible positions are P0CE5.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / E4

Possible causes

  • Open signal, reference or ground wire of the position sensor high
  • Damaged or corroded connector at the valve medium
  • Position sensor inside the valve actuator failed medium

Symptoms

  • MIL or hybrid system warning
  • Valve held in a default position, thermal conditioning limited

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0CE4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication