P0CE3
Hybrid/EV Battery Pack Coolant Control Valve A Control Circuit High
P0CE3 is the short-to-voltage fault of the coolant control valve A drive circuit. GM tests it on the motor-driven four-port battery valve of the 2011 Chevrolet Volt and 2016 Cadillac ELR: driver line 1 reads high while the valve should be stopped or moving forward. System voltage must exceed 9 V or 10.2 V, and 90 of 100 samples at 6.25 ms set a Type B code with the MIL on the second trip. Unlike P0CE2, the check is made in the other direction of travel, which helps tell which condition was detected. Pinched wires touching a supply line, harness damage near the battery or a faulty driver stage in the module are typical causes. Battery temperature control then works only in a fallback mode. Short to ground is P0CE2, mechanical sticking P0CE0 and P0CE1.
Possible causes
- Driver wire pinched against a supply line high
- Harness damage near the battery or valve medium
- Driver stage in the control module faulty low
Symptoms
- MIL after two trips (GM)
- Battery heating or cooling in fallback mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0CE3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.