OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CE2

Hybrid/EV Battery Pack Coolant Control Valve A Control Circuit Low

P0CE2 points to a ground short on the drive circuit of coolant control valve A. In the 2011 Chevrolet Volt and 2016 Cadillac ELR, GM's four-port battery valve is moved by a small motor with two driver lines. The hybrid controller sets P0CE2 when driver line 1 reads low while the valve should be travelling in reverse, with system voltage above 9 V (2011) or 10.2 V (2016); 90 failed samples out of 100 at 6.25 ms create a Type B code, so the MIL comes on after two trips. As long as it is active, the valve performance test is blocked. Typical findings are a wire chafed against the body, water in the connector or an internal short in the valve motor. With the valve stuck in its last position, battery cooling or heating may be restricted. Short to voltage is P0CE3, open circuit P0CDF.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / E2

Possible causes

  • Driver wire chafed through and shorted to ground high
  • Water or corrosion in the valve connector medium
  • Valve actuator motor internally shorted medium

Symptoms

  • MIL after two trips (GM)
  • Valve does not move, battery thermal conditioning limited

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0CE2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication