OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CDF

Hybrid/EV Battery Pack Coolant Control Valve A Control Circuit/Open

P0CDF signals an electrical fault in the drive circuit of coolant control valve A, the valve that routes or shuts off coolant to the hybrid or EV battery. Mercedes-Benz uses it in the battery management unit N82/2 of the S-, E- and C-Class hybrids, where it marks the actuation of the battery module coolant shutoff valve as electrically faulty or interrupted (service information LI83.30-P-061224, together with the stuck codes P0CE0 and P0CE1). An open coil, a broken wire, a corroded plug or a failed driver stage in the control unit are typical. CARB requires output drivers of the battery thermal management to be checked for circuit faults. If the valve cannot be operated, the battery may run too warm or too cold and charging or power can be limited. Shorts to ground or voltage appear as P0CE2 and P0CE3.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / DF

Possible causes

  • Valve coil or actuator motor open high
  • Broken wire or corroded connector at the valve medium
  • Driver stage in the battery or thermal control unit failed low

Symptoms

  • MIL or hybrid system warning
  • Battery cooling or heating not working as intended
  • Reduced charging or drive power

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0CDF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication