OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CDE

Drive Motor A Position Sensor Circuit C Intermittent/Erratic

P0CDE describes a circuit C signal from the drive motor A position sensor that drops out or jumps briefly instead of failing for good. That pattern suits loose terminals at the resolver plug, a harness strained by drivetrain movement, or a winding or contact that opens only when hot. Short glitches matter because the inverter needs the rotor angle continuously; GM therefore evaluates its resolver circuits A and B within fractions of a second (0.25 s in a 0.375 s window). No manufacturer publicly documents P0CDE or the meaning of circuit C, so CARB's requirement to monitor electric drive inputs is the general basis. A dropout can cause a jolt, a hybrid warning or a switch to engine operation, and after a restart the car often drives normally again. A wiggle test with the motor warm helps.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / DE

Possible causes

  • Loose or spread terminal in the resolver connector high
  • Harness strained or chafed by drivetrain movement medium
  • Resolver winding or joint that opens when hot low

Symptoms

  • Occasional jolt or hybrid system warning
  • Temporary switch to engine operation
  • Fault disappears after restart

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0CDE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication