P0CDA
Drive Motor A Position Sensor Circuit C
P0CDA belongs to the rotor position sensor of drive motor A, normally a resolver: an excited stator winding induces signals in pick-up windings so the motor controller can work out rotor angle and speed. SAE counts the circuits of this sensor as A, B and C; GM, for instance, assigns circuit A to the S1/S3 winding and circuit B to S2/S4. What circuit C carries is not described in any public manufacturer document; the excitation winding or an additional signal path would be plausible, but neither is confirmed. No manufacturer publicly documents P0CDA, so CARB's demand to monitor electric drive inputs for circuit faults is the basis. Without a trustworthy angle the inverter cannot control torque, and the system limits or stops electric drive. Plausibility faults are P0CDB, low and high P0CDC and P0CDD.
Possible causes
- Loose, corroded or damaged resolver connector between motor and inverter high
- Damaged resolver wiring medium
- Resolver winding of circuit C defective low
- Evaluation circuit in the motor control module faulty low
Symptoms
- Hybrid system warning and MIL
- Electric drive limited or unavailable, engine runs more
- Reduced regenerative braking
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0CDA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.