P0CD6
Hybrid/EV Battery Pack Coolant Temperature Sensor B Circuit Range/Performance
P0CD6 means that coolant temperature sensor B at the battery outlet is electrically fine, yet its value does not fit the rest of the thermal system. GM runs the check in the hybrid controller of the Volt with the coolant pump above 20 % and no circuit faults present: if the outlet reading is more than 10 °C away from both the inlet reading and the mean cell temperature (2011 Volt, 80 of 100 samples at 100 ms), or at least 20 °C in the 2016 ELR (32 of 40 samples at 250 ms, pump running for over a minute), the result is a Type B code with the MIL following on the second trip. Volvo lists ECM-P0CD623 on the 2016-17 XC90 T8 as an incorrect entry cured by a total software upgrade (TJ 32193). Otherwise a drifting sensor, contact resistance or trapped air are likely.
Possible causes
- Outlet coolant temperature sensor reading off (drift) high
- Contact resistance at connector or terminals medium
- Air or low coolant in the battery loop after service medium
- Control module software sets the code incorrectly (e.g. Volvo XC90 T8) low
Symptoms
- MIL on, often without noticeable driving symptoms
- Battery cooling or heating behaves unexpectedly
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0CD6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.