P0CD5
Hybrid/EV Battery Pack Coolant Temperature Sensor B Circuit
P0CD5 is the general circuit fault for the second coolant temperature sensor in the liquid loop of a hybrid or EV battery. In GM's tables for the Chevrolet Volt and Cadillac ELR, sensor B is the one at the pack outlet, an NTC thermistor read by the battery energy control module, while sensor A sits at the inlet. GM splits electrical faults of sensor B into P0CD7 and P0CD8 and does not list P0CD5 itself. No manufacturer publicly documents this general code; it suits controllers that only recognise an unusable signal without telling low from high. CARB requires battery thermal management inputs to be checked for circuit faults. Without the outlet value the controller no longer knows how much the coolant warms across the pack and may limit charging or drive power. Implausible readings fall under P0CD6.
Possible causes
- Loose, corroded or unplugged connector or damaged wire at the outlet sensor high
- Coolant temperature sensor B defective medium
- Input circuit or reference in the battery control module faulty low
Symptoms
- Check engine or hybrid system warning lamp
- Reduced charging or drive power, especially in heat or cold
- Battery heating or cooling runs on substitute values
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0CD5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.