P0CD4
Charge Port Door A Unlock Control Circuit High
P0CD4 is the high-level variant of the charge flap A unlock output fault. The control line reads high when the driver should be pulling it low or holding it off, as happens with a short to a 12 V wire, and on many low-side drivers also with an open actuator or broken wire. A flap actuator that is powered all the time may overheat, while an open one simply never releases. No manufacturer documents this code publicly; GM's Volt tables cover short to battery and open circuit within P0CD1. A Tesla patent describes the same principle, in which a controller closes a switch to supply the flap release actuator. CARB 13 CCR 1968.2 (e)(15) explains why comfort outputs like this rarely receive split low and high codes. Siblings: P0CD3 for low, P0CD2 for the movement check.
Possible causes
- Actuator control wire shorted to a 12 V feed high
- Open actuator winding or broken wire medium
- Output driver in the control module damaged low
Symptoms
- Charge flap does not unlock or unlocks unexpectedly
- Actuator may become hot from continuous current
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0CD4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.