OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CD2

Charge Port Door A Unlock Control Circuit Performance

P0CD2 is a functional test: after commanding charge flap A to unlock, the module waits for the position sensor to report the flap open. GM documents it for the Chevrolet Volt. The 2011 table allows 5 seconds, the 2012 and 2013 tables 13 seconds, and the 2013 version only runs above minus 12 °C. The test is skipped while P0CCC, P0CCE, P0CCF or P0CD1 is active, so P0CD2 means the electrics look fine but the flap did not move. It is a Type B code with the lamp after two trips. Frozen or binding flaps are a typical cause: GM bulletin PI0936 covers 2013 Volts whose flap would not open in the cold because of a misaligned hinge pin, and Porsche replaced jamming flap switching elements on the 918 Spyder.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / D2

Possible causes

  • Flap frozen, stuck to the seal or binding at the hinge high
  • Weak or mechanically blocked unlock actuator medium
  • Misaligned charge port housing or hinge pin (GM PI0936) medium
  • Position sensor not registering the open flap low

Symptoms

  • Flap does not open, especially in frost
  • Warning lamp after two trips (GM Volt)

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0CD2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication