P0CD1
Charge Port Door A Unlock Control Circuit
P0CD1 is the circuit fault of the output that releases charge flap A, normally a relay or driver that briefly powers the latch actuator. A GM patent shows such an actuator retracting a post so the spring-loaded flap can pop open. On the 2011 to 2013 Chevrolet Volt the hybrid control module 2 relies on the fault status its driver reports and covers two cases: short to ground, judged while the unlock is commanded, and a short to 12 V or an open line, judged while it is not, using sample counts such as 64 of 80 at 50 ms. It is a Type B code with the lamp after two trips, and an active P0CD1 blocks the opening check P0CD2. Split low and high codes (P0CD3, P0CD4) are not used there. Result for the driver: the flap stays shut.
Possible causes
- Unlock actuator coil open or shorted high
- Faulty charge flap relay or its control wire medium
- Chafed or corroded wiring to the actuator medium
- Output driver in the control module damaged low
Symptoms
- Charge flap does not unlock
- Warning lamp after two trips (GM Volt)
- Emergency release needed to reach the charge socket
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0CD1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.