Powertrain
generic / SAE
P0CCE
Charge Port Door A Position Sensor Circuit Low
The charge port door A position sensor reports a low fault. Door state cannot be verified reliably. The on-board charger negotiates voltage, current and safety with the EVSE; a fault interrupts charging or limits it to AC slow-charge despite a DC fast charger being attached.
SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / CE
Possible causes
- Signal wire shorted to ground high
- Internal sensor short medium
- Connector pins corroded - high contact resistance low
Symptoms
- Charge status indicator shows fault
- Charging may not start or interrupts
- Slower-than-expected charge rate
Inspection / repair
- Difficulty: easy
- DIY: possible
- Estimated cost: 80–400 €
- Estimated time: 0.3–2 h
- Component: charge port door a position sensor
- Component: wiring harness
- Component: bms
- MIL / check engine light
Sources
References
sae:J2012