P0CCD
Charge Port Door A Position Sensor Circuit Performance
P0CCD is set when the charge flap A position signal is electrically valid but does not fit what the flap should be doing, for example a state that disagrees with the last commanded movement. GM bulletin 25-NA-049 (March 2025) names the code for the Ultium models Cadillac Lyriq 2023 to 2025, Chevrolet Blazer EV and Equinox EV 2024 to 2025, and Cadillac Optiq and Escalade IQ 2025: drivers see a Service High Voltage message, the cause is attributed to software, and dealers are told to reflash the BECM (battery energy control module) through vehicle wide programming without replacing parts. Porsche describes a related hardware case for the Taycan, where a wrong end-position signal locked the opposite flap and new harnesses fixed it. Circuit faults proper are P0CCC, P0CCE and P0CCF.
Possible causes
- Software anomaly in the battery control module (GM Ultium, bulletin 25-NA-049) high
- Position sensor giving a wrong end-position signal medium
- Faulty harness between flap module and control unit medium
- Flap not reaching its end position because of mechanical binding low
Symptoms
- Service High Voltage message (GM Ultium models)
- Flap status shown wrongly; another flap may be locked
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0CCD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.