OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CC6

Charge Port Door A Open Request Switch Wake-Up Circuit

On plug-in vehicles the button that asks for the charge flap to open must also be able to rouse a sleeping control module, so it drives a separate wake-up line besides its normal signal. P0CC6 records that these two signals disagree. GM documents the code for the 2011 Chevrolet Volt, where the hybrid control module 2 (VICM) checks two cases: wake-up active although the switch reads released, and switch pressed with no wake-up seen. Both are filtered over 50 ms samples and stored as Type B after two trips with the warning lamp. The test is skipped while P0CC7, P0CC9 or P0CCA is active, so P0CC6 points to the wake-up wire or the switch contact itself. The driver mostly notices that pressing the button sometimes does not open the flap.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / C6

Possible causes

  • Open, chafed or shorted wake-up wire between switch and control module high
  • Worn or contaminated contact in the open request switch medium
  • Corroded or loose pins at the switch or module connector medium
  • Faulty wake-up input inside the control module low

Symptoms

  • Charge flap opens only after several presses or not at all
  • Warning lamp after two trips (GM Volt)
  • Possible extra drain on the 12 V battery if the module is kept awake

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0CC6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication