P0CC5
14 Volt Power Module Current Sensor A/B Correlation
P0CC5 compares the two current sensors of the 14 V power module, the DC/DC converter that feeds the 12 V network from the high-voltage battery. In GM's 2013 eAssist table 13OBDG05C, where the unit is the accessory power module (APM), sensor A measures the input and sensor B the output side. The module computes an input power, multiplies it by an efficiency factor taken from a table (0.99 down to 0.90) and compares the result with the power derived from the output side; a gap above 0.4 kW for 3.75 s within a 5 s window, at 9 to 32 V and with the input power inside the enabling window the table ties to 1.25 kW, is a Type B fault. The check is suspended while the single-sensor codes P0A88/P0A89 or P0C9E/P0C9F are active. One drifting sensor is the usual reason, and a 12 V battery that stays poorly charged is a typical sign.
Possible causes
- Offset or gain drift of one current sensor high
- Internal fault of the power module, e.g. real efficiency loss medium
- Calibration or software fault in the module low
Symptoms
- Check-engine lamp after the second faulty trip
- 12 V battery not fully charged or low-voltage warning
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0CC5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.