OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CC4

Drive Motor A Coolant Pump Control Circuit High

P0CC4 stands for a control line of the drive motor A coolant pump that is held at supply voltage or overloaded. In GM's 2013 eAssist table 13OBDG05C the output driver reports a high-circuit status, and unlike the open and low checks this one runs while the pump is commanded on; 20 failures in 25 samples at 250 ms in run/crank set a Type B code, two trips. Sampling with the output switched on lets the driver recognise excess current or a voltage that should not be there. Causes include a control wire chafed against a battery-positive feed, a pump drawing too much current because of a jammed rotor, or water in the connector. The output stage normally switches off to protect itself, so the pump stops and the motor generator loses active cooling; P0CC3 and P0CC1 are the other circuit codes of this pump.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / C4

Possible causes

  • Control wire shorted to a voltage-carrying line high
  • Jammed pump drawing excess current medium
  • Water ingress in the pump connector low

Symptoms

  • Check-engine lamp after two trips
  • Pump silent when it should run

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0CC4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication