OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CC3

Drive Motor A Coolant Pump Control Circuit Low

P0CC3 indicates that the control line of the drive motor A coolant pump is pulled to ground. GM lists it for the 2013 eAssist cars in table 13OBDG05C: the hardware status of the output driver signals a low-circuit fault, and 20 of 25 samples at 250 ms with the pump commanded off and the vehicle in run/crank fail the test, Type B, so the MIL is lit after the second trip. Typical are chafed insulation where the harness passes brackets or the engine, or a pump with an internal short. Depending on how the driver stage is built, a grounded line can also leave the pump running permanently or stop it, so either constant pump noise or missing cooling is possible. Compared with the open-circuit code P0CC1 and the short-to-voltage code P0CC4, the repair focuses on finding the point of ground contact.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / C3

Possible causes

  • Chafed control wire touching ground high
  • Internal short in the pump medium
  • Faulty output stage in the control module low

Symptoms

  • Check-engine lamp after two trips
  • Pump running constantly or not at all
  • Reduced electric assist

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0CC3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication