OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CC2

Drive Motor A Coolant Pump Control Circuit Range/Performance

P0CC2 judges whether the pump for drive motor A actually moves coolant, not only whether its wiring is intact. GM's 2013 eAssist table 13OBDG05C infers flow from temperature: when the model predicts more than 17 °C between the jacket coolant of the motor generator and the coolant reaching the loop sensor, a running pump should make the sensor warm up quickly. If its rate of change stays at 0.25 °C per second or less 20 s after the pump was switched on, the test fails, Type B, two trips, with over 10 V supply. The check is blocked by pump circuit codes P0CC1/P0CC3/P0CC4, by the loop sensor codes P0CBD to P0CBF and by stator sensor codes P0A2B to P0A2D. A seized or air-locked pump, low coolant or a blocked hose are typical; CARB section (e)(15.2.2) requires such functional checks of output components.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / C2

Possible causes

  • Air in the motor generator cooling loop, often after service high
  • Worn or seized pump impeller medium
  • Low coolant level or kinked or blocked hose medium

Symptoms

  • Check-engine lamp
  • Electric assist reduced as the motor generator heats up

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0CC2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication