P0CC1
Drive Motor A Coolant Pump Control Circuit/Open
P0CC1 concerns the control circuit of the electric pump that moves coolant through the loop of drive motor A, here specifically an open circuit. GM documents it for the 2013 eAssist hybrids, where the table 13OBDG05C calls the part the motor generator coolant pump: the output driver reports an open-circuit status, and 20 of 25 checks at 250 ms intervals with the vehicle in run/crank and the pump commanded off fail the test, Type B, two trips. Checking in the off state lets the driver detect a missing load without running the pump. A broken wire, a corroded pump connector or an open motor winding are typical causes. With the pump not reachable, the motor generator cannot be cooled actively, so the system is likely to limit assist and charging; the short codes P0CC3 and P0CC4 belong to the same circuit.
Possible causes
- Broken control or supply wire to the pump high
- Corroded or unplugged pump connector medium
- Open winding inside the pump motor medium
Symptoms
- Check-engine lamp after two trips
- Less electric assist and regeneration
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0CC1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.