P0CBF
Drive Motor A Coolant Temperature Sensor Circuit High
P0CBF is the code for an excessive signal from the coolant temperature sensor of drive motor A. With an NTC element a very high resistance stands for extreme cold, so in practice an open sensor, a broken wire or a disconnected plug is behind it. In GM's 2013 eAssist table 13OBDG05C the code is set when the raw value exceeds 176,962 Ω, the equivalent of −40 °C, in 50 of 62 samples at 100 ms with ignition in run/crank, Type B, two trips. Because −40 °C is a real if rare ambient temperature, the check uses a resistance far beyond the normal working curve. With the loop temperature unknown, the system has to fall back on substitute values and may scale back the electric assist. The codes P0CBD and P0CC2 rely on this sensor and are blocked while P0CBF is present; P0CBE is its low counterpart.
Possible causes
- Open signal or return wire, or unplugged sensor high
- Sensor element open internally medium
- Corroded pins at sensor or control module low
Symptoms
- Check-engine lamp after two trips
- Coolant temperature of the motor shown at minimum value
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0CBF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.