OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CBE

Drive Motor A Coolant Temperature Sensor Circuit Low

P0CBE says the coolant temperature input of drive motor A is below its valid range, meaning the sensor resistance has become very small. GM's 2013 eAssist table 13OBDG05C sets the code when the raw reading is under 100.9 Ω, which equals 120 °C, in 50 of 62 samples taken every 100 ms with the vehicle in run/crank; it is a Type B fault, so the lamp comes on after the second trip. Such a low value is usually a shorted sensor or a signal line rubbing through to ground. GM's preliminary information PIC5720A for 2012–2013 LaCrosse and Regal, 2013 Malibu Eco and 2014 Impala Eco with eAssist describes exactly that: a misrouted harness touching the crank, A/C compressor pulley or belt, together with C027B and C0040 and a humming noise. Its partner for an open circuit is P0CBF.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / BE

Possible causes

  • Harness rubbing on crank or compressor pulley or belt (GM PIC5720A) high
  • Coolant temperature sensor shorted internally medium
  • Loop genuinely very hot, e.g. pump or coolant fault low

Symptoms

  • Check-engine lamp, possibly with ABS or brake assist warning
  • Hum or buzz from the right front
  • Electric assist restricted

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0CBE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication