P0CBD
Drive Motor A Coolant Temperature Sensor Circuit Range/Performance
P0CBD reports that the coolant temperature sensor of drive motor A gives a believable voltage but an implausible temperature. GM uses it on the 2013 eAssist models, where the drive motor is the belt-driven motor generator with its own small cooling loop. Table 13OBDG05C runs the check once per key cycle after an engine-off period of more than 21,600 s: the loop sensor is compared with the mean of stator temperature, intake air temperature and transmission fluid temperature, and a difference above 25 °C in 50 of 62 samples at 100 ms is a Type B fault. The test is skipped while stator sensor codes P0A2B–P0A2D, intake air or transmission fluid sensor codes, the sensor's own P0CBE/P0CBF or CAN faults U0100/U0101 are active. A drifting sensor is the likely cause; the motor generator may be limited meanwhile.
Possible causes
- Coolant temperature sensor drifted out of its curve high
- Added resistance from a corroded connector medium
- One of the comparison sensors (stator, intake air, transmission oil) reading wrongly low
Symptoms
- Check-engine lamp after the second faulty trip
- Reduced electric assist or regeneration
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0CBD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.