P0CBC
Drive Motor A Coolant Temperature Sensor Circuit
P0CBC is the general code for the sensor that measures coolant temperature in the cooling loop of drive motor A. Volvo and Polestar document it as P0CBC62 in the inverter module IEM of the Polestar 2 and the XC40/C40 Recharge (Technical Journals 37523 and 37521 from 2025): failure type 62 marks a signal comparison fault, and the vehicle displays a propulsion service message. In many of these cars the root cause was a defective check valve in a coolant hose, not the module. The phase transistor temperatures then swing widely while driving; at 80–100 °C the IEM sets a temperature code and freewheels, which stops a single-motor car and halves power on dual motors. Before replacing the IEM, plot those temperatures and renew the valve hose. CARB section (e)(15.2.3)(B)(ii) covers inverter cooling inputs.
Possible causes
- Faulty one-way valve in the drive unit coolant hose (Volvo/Polestar TJ 37521/37523) high
- Low coolant or trapped air in the drive motor loop medium
- Sensor or wiring fault in the temperature circuit low
- Internal fault of the inverter module low
Symptoms
- Propulsion system service message
- Loss of drive power, car may stop on single-motor versions
- Half power only on dual-motor versions
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0CBC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.