OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CBA

Hybrid/EV Battery Temperature Sensor P Circuit High

P0CBA appears when the signal of sensor P rises above its upper voltage limit, the typical picture of an open circuit: without a closed path through the thermistor, the pull-up resistor drives the input high and the computed temperature drops to an absurd value. GM's 2019 HPC2 table 19OBDG02 fails it when 8 of 10 readings at 100 ms fall below −69 °C, Type B, provided supply exceeds 10.2 V and the battery interface control module is online. In the 2011 Volt table the limit was −40 °C, a raw count above 4,000, held 1.4 s within 2 s, and a single trip set the code. On the Outlander PHEV, Mitsubishi files P0CBA as an open circuit of module sensor [15] once the voltage stays above 3.97 V for 2 s. Cold-weather strategies such as pack heating may then start needlessly; P0CB9 is the matching low code.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / BA

Possible causes

  • Open circuit or disconnected plug of sensor P high
  • Thermistor P broken internally medium
  • Spread or corroded terminal on the sensing board low

Symptoms

  • Very low battery temperature displayed on a warm day
  • Battery heater or engine running more than usual

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0CBA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication