P0CB9
Hybrid/EV Battery Temperature Sensor P Circuit Low
P0CB9 means the voltage of sensor P has fallen under the valid range. As with the other NTC sensors, low voltage corresponds to high temperature, so a short to ground or a collapsed thermistor makes the module appear to be glowing hot. In GM's HPC2 tables 18OBDG02 and 19OBDG02 the code is set after 8 of 10 readings above 160 °C at 100 ms spacing, Type B, two trips, once system voltage exceeds 10.2 V and the battery interface module communicates. The 2011 Volt table already contained it with 87.5 °C, a raw count below 680, held 1.4 s within 2 s. Mitsubishi treats P0CB9 as a short of module sensor [15] of the Outlander PHEV, below 0.12 V for 2 s, lists no fail-safe function and names battery module or cell monitoring unit as the parts to replace. A genuinely hot pack is reported by P0A7E.
Possible causes
- Sensor P signal shorted to ground high
- Thermistor P internally shorted medium
- Damaged input of the cell monitoring unit for sensor P low
Symptoms
- Module P shown as extremely hot in live data
- Severe power limitation with warning lamp
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0CB9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.