OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CB8

Hybrid/EV Battery Temperature Sensor P Circuit Range/Performance

P0CB8 flags sensor P as implausible: its value is electrically fine, but after a long rest it disagrees with the temperature of the other modules. GM runs this comparison in the 2012 Volt table 12OBDG01A only when drive system, external charging and battery conditioning have rested for over 21,600 s, so the whole pack should have settled; 50 of 67 samples more than 25.3 °C from the average give a Type B fault. In the HPC2 table 18OBDG02 the limit is 25.00 °C, sampled every 25 ms for about 1.7 s, and the check is held back by circuit or erratic faults and by lost communication. Mitsubishi uses P0CB8 for module sensor [15] of the Outlander PHEV with a 13 °C limit over 0.32 s after more than 3,600 s soak. Comparing all sensors in live data after an overnight stand shows the outlier.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / B8

Possible causes

  • Thermistor P drifted out of calibration high
  • Sensor P detached from its module surface medium
  • Real temperature difference of that module, e.g. faulty cell low

Symptoms

  • Warning appearing at the first drive after a long stand
  • Battery output restricted

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0CB8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication