OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CB5

Hybrid/EV Battery Temperature Sensor O Circuit High

P0CB5 is stored when the input of sensor O sits above its upper voltage limit. An open thermistor, a broken wire or a loose plug lets the pull-up resistor raise the input, so the controller sees a temperature colder than any real pack could be. GM sets it in the HPC2 table 18OBDG02 when 8 of 10 readings at 100 ms intervals come out below −69 °C, Type B, with supply above 10.2 V and intact communication with the battery interface module. The 2011 Volt table drew the line at −40 °C, a raw count above 4,000, for 1.4 s within 2 s, and there one trip sufficed. For the Outlander PHEV, Mitsubishi reads P0CB5 as an open circuit of module sensor [14]: above 3.97 V, below about −62 °C, for 2 s. A plug-in may then warm the pack for nothing or run the engine more; P0CB4 is the low twin.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / B5

Possible causes

  • Open lead or unplugged connector of sensor O high
  • Thermistor O open internally medium
  • Corroded or loose terminal at the sensing board low

Symptoms

  • Pack shown as extremely cold regardless of weather
  • Less electric power, engine running more on plug-in hybrids

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0CB5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication