P0CB4
Hybrid/EV Battery Temperature Sensor O Circuit Low
P0CB4 reports a signal voltage of sensor O below its lower limit. The sensor is an NTC thermistor biased by a resistor on the measuring board, so a short to ground or a shorted element looks like extreme heat. GM's HPC2 table 18OBDG02 fails the test when the converted value is above 160 °C in 8 of 10 readings at 100 ms, Type B, with more than 10.2 V supply; the 2011 Volt table used 87.5 °C, a raw count below 680, for 1.4 s within a 2 s window over two trips. In GM's 2019 table the pack over-temperature monitor P0A7E is suspended while such short codes are active, because a false hot reading would otherwise trigger it. Mitsubishi calls P0CB4 a short of module sensor [14] on the Outlander PHEV: under 0.12 V, roughly above 125 °C, for 2 s.
Possible causes
- Signal lead of sensor O shorted to ground in the pack high
- Thermistor O shorted internally medium
- Input stage of the cell monitoring unit defective low
Symptoms
- Live data showing an implausibly hot module
- Strongly reduced battery power with warning lamp
- Battery cooling running without obvious need
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0CB4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG02 Hybrid Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2019/19OBDG02 Hybrid Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2011/11OBDG01 HYBRID Diagnostics.pdf
- mitsubishitechinfo.com/data/REEV/2018/54/HTML/M154940770001700USA.htm
- mitsubishitechinfo.com/data/REEV/2018/54/HTML/M154940060025701USA.htm