OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CB3

Hybrid/EV Battery Temperature Sensor O Circuit Range/Performance

P0CB3 is a plausibility code: sensor O delivers an electrically valid reading, yet it strays too far from the rest of the pack. In GM's 2012 Volt table 12OBDG01A the check waits until propulsion, plug-in charging and battery thermal conditioning have all been off for more than 21,600 s; a gap above 25.3 °C to the average in 50 of 67 samples then counts as a Type B failure. The HPC2 tables 18OBDG02 and 19OBDG02 use 25.00 °C, sample every 25 ms and pause while sensor circuit faults or a communication loss with the battery electronics are present. Mitsubishi assigns P0CB3 to module sensor [14] of the Outlander PHEV and fails it at a deviation of 13 °C or more held for 0.32 s, after a soak above 3,600 s and with the pack between −30 and 60 °C.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / B3

Possible causes

  • Thermistor O drifting while its voltage stays in range high
  • Sensor O no longer seated firmly against its module medium
  • Module section really warmer or colder, e.g. weak cell or uneven cooling low

Symptoms

  • Warning lamp typically appearing after the car has stood for hours
  • Battery power limited

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0CB3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication