OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0CB2

Hybrid/EV Battery Temperature Sensor O Circuit

P0CB2 is the catch-all electrical code for battery temperature sensor O, reserved for circuit faults that are not classified as low, high or erratic. Publicly, no manufacturer documents this exact code. Counting the rationality list in GM's 2011 Volt table puts O in position 15 of 16, but GM only uses P0CB3 to P0CB6 for it. Mitsubishi maps O to module sensor [14] of the Outlander PHEV and likewise relies on the rationality, short and open codes alone. CARB section (e)(15.2.3)(A)(iv) counts battery temperature sensors among the inputs that have to be monitored, and (A)(v) asks for codes that point to the smallest replaceable unit. With O unusable, the controller has to guess the module temperature and normally cuts battery power. The thermistor sits inside the pack, so repair is a high-voltage job.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / B2

Possible causes

  • Poor contact at the sensor O connector on the monitoring board high
  • Damaged lead between thermistor O and the board medium
  • Faulty measuring channel in the cell monitoring unit low

Symptoms

  • Hybrid or EV system warning, possibly with check-engine lamp
  • Reduced electric power or charging rate

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0CB2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication